PixelForge Help Open editor

Open your first image

Open a photo from your device, drop it on the editor or paste it from the clipboard, and see what happens to the file.

BeginnerUpdated 2026-11-14

When you open the editor for the first time it shows a sample picture so you can try the tools straight away. Open one of your own images to replace it.

The Open image button in the editor's top bar
Open image is in the top bar, next to Export

#Open an image

  1. Click Open image in the top bar, or choose File > Open image… (Ctrl+O, ⌘+O on Mac).
  2. Pick a file on your device. PNG, JPEG and WebP open in every current browser; see Supported file formats for the others.
  3. The image opens as a new document with one Background layer, fitted to the window.

You can also drag a file from your desktop onto the editor. Dropping it while a document is open adds it as a new layer instead; hold Shift while dropping to open it as a new document. See Open and place files.

#What happens to the file

  • The image is decoded in your browser. It is not uploaded anywhere.
  • It becomes a new draft that autosaves in this browser. The document you had open before stays saved as its own draft (see Drafts and saving).
  • The image keeps its full resolution, up to 16 megapixels and 16,000 pixels on a side. Larger images are refused with a message, and your current document is left unchanged.
  • Files larger than 64 MB are refused.
  • Camera metadata (EXIF, GPS) and embedded colour profiles are not kept. Exports contain only the edited pixels.

#When an image will not open

The status line at the bottom of the editor explains why. The most common reasons are a camera RAW file (develop it to JPEG or PNG first), a HEIC photo in a browser that cannot decode HEIC, or an image over 16 megapixels. See Troubleshooting.

#Next steps

Still stuck? See Troubleshooting or report a problem.